Modular Kitchen in Kukatpally, Hyderabad
Modular Kitchens Built For Kukatpally Towers
Ask which floor the flat is on and which way the kitchen faces and you already have half the brief in Kukatpally, where the towers rise straight off the shop lined main stretch and the kitchen window usually looks down on it. A window on that side brings light, horns and a film of road grime in equal measure, and it also decides where cooking air is allowed to leave the flat. So the tape comes out in your own kitchen, on your own floor, with the traffic audible through the glass.
Kukatpally, Hyderabad 500072
Modular Kitchen in Kukatpally
Tell us about the space and we will come out to Kukatpally for a free site visit, then quote it line by line.
What Improves In A Tower Kitchen Here
Some of this is settled overhead before a shutter is chosen, because the vent line, the loft height and the false ceiling that conceals the duct above your wall units all have to agree on one level.
Road Side Window Kept
The one window your flat faces the road with keeps its full opening, so storage in front of it stays low and daylight still reaches the board you chop on.
Vent Path Off The Face
The hood is set so its duct leaves by the shortest line to the outer face of the building, which is what keeps the smell of cooking out of the bedroom behind the kitchen wall.
Quiet On A Loud Street
Hinges and runners that pull themselves shut stop the kitchen adding to what the road already sends up, and the shutters sit tight enough not to rattle when a lorry passes below.
Room To Step Past
The gap between the run and the opposite wall is held wide enough for one person to reach the fridge while another stands at the hob, which is the first thing a narrow tower kitchen loses.
Waste Leaves Daily
A segregated pull out under the sink keeps the wet and dry bins behind a shutter until the collection round comes, so nothing stands open in a kitchen that shares its air with the living room.
Faces That Wipe Clean
Shutter finishes are chosen for a kitchen that takes road dust through an open window, so a week of grime comes off with a cloth instead of settling into a textured surface.
How A Kukatpally Fit Out Runs
- Drain Read, Not Guessed
- We open the cupboard under your existing sink point and look at the inlet and the fall before proposing a layout, because moving a drain on an upper floor is a decision you should take with your eyes open.
- Lift And Landing Measured
- Service lift depth, the turn off the landing and your door width are taken first, so a tall unit arrives in sections that genuinely reach your floor rather than standing in the lobby.
- Society Timings Respected
- The loading window and the hours your block permits drilling are confirmed at the office before the first delivery, so the job is not stopped halfway by a neighbour on the floor below.
- Cutting Done Off Site
- Panels are cut and banded at the workshop and the doorway is sheeted before assembly, which keeps the fine dust of a dense block out of the rest of the flat and out of your lungs.
- Piped Gas Point Fixed
- In a tower the gas point is where the supplier left it and not where a drawing would prefer, so the hob is planned to that point and the cabinets either side are built around the pipe.
Questions From Kukatpally Towers
Our kitchen window faces the main road. Can a hood still take the smoke out?
Yes, and the window is where we start. The hob is placed so the hood sits over it without covering the opening, then the duct is taken by the shortest line to the outer face so nothing is pushed back into the room. On a road side kitchen the vent line and the window clearance are settled on the first visit, long before shutter colours come up.
We are on a high floor and the service lift is small. Will the units even reach us?
That is measured before anything is fabricated. We take the lift's internal depth, the landing turn and your door width, then break the tall units into sections that pass all three and join them inside the kitchen. Where the lift will not take a piece it is made to a size that will, and the joint is placed where a shutter covers it.
Someone is home all day. How loud and how dusty is this going to be?
Cutting and banding happen at the workshop, so what runs in your flat is drilling, fixing and assembly. We sheet the doorway and the floor, keep a vacuum at the drill where we can, and work inside the hours your block allows. The noisiest stretch is the wall fixing, and we tell you which day that falls on so you can be out.
See The Kitchen On Your Floor
Send the tower name, the floor and an hour when the kitchen is free. Someone comes up from the studio at Ambedkar Statue in Narsingi, measures the run against the window and the gas point, checks how material will reach you, and follows with a quote written line by line. The visit costs nothing. Call or WhatsApp +91 79892 32675.
Tell us about your space
Send the form and we will call you back to arrange a free site visit, or just pick up the phone. The consultation, the measurement and the quote cost nothing.
- Call the studio
- +91 79892 32675
- Visit
- Ambedkar Statue, Narsingi
Hyderabad, Telangana 500075 - Open
- Monday to Sunday, 9:00 AM to 8:00 PM